I had never received that Atos error message before in all my years of using SketchUp. Not that I don't usually, but when I am pressed for time I do sometimes forget. Is there anything that I can do to get around this problem when using SketchUp, or am I just going to have to be very very sure to save every two seconds and prior to exporting my render. I was about to write the developer of LightUp who is unbelievably helpful, to ask if he thought it was a LightUp problem, and your good-selves as to whether it could be SketchUp issue, but decided instead to Google the word Atos to see if I could find out what it was? Apparently, and I did not read the entire article, it is something connected to Apple's operating system, and so therefore there is now one other "fail" to add to the entire Yosemite nightmare. ![]() Regardless of whether I say yes or cancel, SketchUp crashes. I have been on the verge of tears many a day.Īnother problem that I have noticed, is that on attempting to export a render from SketchUp and using LightUp, I keep getting a message from something called "Atos" requesting permission to debug. The worst for me being kicked off of the internet every three minutes, and which makes working virtually impossible. I am sure you have been following the posts as to its many and assorted problems. ![]() Like an idiot, and only because I knew someone who had installed the beta and had no problems, I upgraded (bad choice of a word) to OSX Yosemite a couple days after its launch.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |